[CLUG] hard drive enclosure for ATA100 laptop hard drive?

[Conor O'Callaghan]

Ya we had the same thing, you had to pull off the gray yoke and put on the 2
1/2" adaptor onto the pins then

On 05/11/2007, justin flavin <justinf at gmail.com> wrote:
>
> http://i22.tinypic.com/50hauq.jpg
> http://i21.tinypic.com/jgjj3d.jpg
> http://i23.tinypic.com/116hpoh.jpg
>
> i went down to maplins and they had that yoke in stock - but the
> interfaces
> didnt
> match what i had on my drive (see attached pictures)
>
> model is seagate ST94019A
>
> unless i pull off that grey yoke sticking out at the bottom to expose the
> hdd pins?
> (bit risky as i might break it...)
>
> any idea what that interface type is - UDMA100?
>
>
> On 11/5/07, Conor O'Callaghan <cocallaghan at gmail.com> wrote:
> >
> > In fact Im sure it was a HP laptop like that I used it on. It was easily
> > detected as an external USB disk in Suse and you could browse around
> > through
> > the files.
> >
> > I managed to pick up a connector which does 2.5" 3.5" and SATA
> connections
> > > to USB complete with power as necessary. Managed to get it in maplin.
> It
> > was
> > > a bit expensive, but Im sure there is cheaper than maplin online
> > somewhere.
> > >
> > >
> > _______________________________________________
> > Cork mailing list
> > Cork at linux.ie
> > http://mail.linux.ie/mailman/listinfo/cork
> >
>
>
>
> --
> ********************************************
> skype: justinflavin
> http://linuxnotes.blogspot.com
> _______________________________________________
> Cork mailing list
> Cork at linux.ie
> http://mail.linux.ie/mailman/listinfo/cork
>