You have something like
append="ether=11,0x6500,eth0 ether=9,0x300,eth1"
in your /etc/lilo.conf? Or in config.sys if you're using loadlin..
Check /etc/interrupts. It might give more info..
Did you try and start eth1 later with ifconfig?
/sbin ifconfig eth1 down
/sbin ifconfig eth1 up
Hope that helps,
Donncha.
Mel wrote:
>> I am connected here on two seperate networks and I'm trying to talk to
> both of them at the same time. I have the correct modules installed and I
> have the routing information set up properably but when I try to initilase
> eth1, I get
>> Delaying eth1 initialization.
>> but it doesn't say why. I've read the multiple card ethernet howto but it
> had no information on it. What steps do I have to go through to get onto
> both networks?
Maintained by the ILUG website team. The aim of Linux.ie is to
support and help commercial and private users of Linux in Ireland. You can
display ILUG news in your own webpages, read backend
information to find out how. Networking services kindly provided by HEAnet, server kindly donated by
Dell. Linux is a trademark of Linus Torvalds,
used with permission. No penguins were harmed in the production or maintenance
of this highly praised website. Looking for the
Indian Linux Users' Group? Try here. If you've read all this and aren't a lawyer: you should be!
