[ILUG] eepro on Redhat 7.1?

[Wynne, Conor]

Use the e100 module from Intel. Its your only man, or go to scyld and get theirs...

I had an issue with an eepro100 whereby it worked as long as high loads and/or DHCP were avoided. It would disconnect with errors. I could reconnect a la ifdown eth0, ifup eth0 (redhat) 
Installed the e100 and works grand. 

Cannot remember the scyld address, google baby.

CW

------------------------------
We had a network card problem on a standard Redhat 7.1 (2.4.2-2 smp)
machine this morning, solved it by swapping in a different card, but I
dunno why it was "broken" in the first place ....any suggestions on how to
find the cause would be welcome as I want to avoid this in the future....

The card was an eepro, usng eepro100 in modules.conf
the machine could ping itself, and ifconfig showed it's MAC address and ip
address ok
machines on the lan could not ping it, nor could it ping them
"service network start|stop" ran without errors
it had worked without problems until today.
the card worked ok in an NT machine afterwards



/var/log/messages doesn't show anything (at least to this untrained eye)



...Garret



----------------------- D I S C L A I M E R ---------------------

The opinions, conclusions and other information expressed in the above
message, or contained within attachments to the above message, are not
given or endorsed by Beaumont Hospital unless otherwise indicated by an
authorised representative independent of this message.

This e-mail message and any files transmitted with it are confidential and
intended solely for the use of the individual or entity to whom they
are addressed. If you have received this e-mail in error please notify
the system manager.

This e-mail has been scanned for viruses.

------------------------------------------------------------------