[ILUG] connecting at 1200bps in RH7.3 (help!)

[John McCormac]

Colin Nevin wrote:
> 
> Hi All,
> The modem handshake works at slightly higher speeds (4800bps to
> ~57600bps) but that is no good for tx/rx'ing data to the remote server
> as it insists at talking at the speed of treacle/1200bps.

It sounds like the flow control is set to Xon/Xoff rather than hardware.

> Baud 1200 7 data bits Even Parity

Unusual -  8 n 1 is more common.

> 
> I am doing a ATZ3 to reset the modem then I send this init string:
> 
> AT&F1E1V1Q0X4Y0S32=232&A1&B0&C1&D2&H0&I0&K1&M4&N0&P0&R1&S0&U0&Y1

I think that the AT command for hardware flow control is &E4 though this
may vary from modem to modem.

Regards...jmcc
-- 
********************************************
John McCormac            * Hack Watch News
jmcc at hackwatch.com       * 22 Viewmount, 
Voice:   +353-51-873640  * Waterford,
BBS&Fax: +353-51-850143  * Ireland
http://www.hackwatch.com/~kooltek
********************************************

-----BEGIN PGP PUBLIC KEY BLOCK-----
Version: 2.6

mQCNAzAYPNsAAAEEAPGTHaNyitUTNAwF8BU6mF5PcbLQXdeuHf3xT6UOL+/Od+z+
ZOCAx8Ka9LJBjuQYw8hlqvTV5kceLlrP2HPqmk7YPOw1fQWlpTJof+ZMCxEVd1Qz
TRet2vS/kiRQRYvKOaxoJhqIzUr1g3ovBnIdpKeo4KKULz9XKuxCgZsuLKkVAAUX
tCJKb2huIE1jQ29ybWFjIDxqbWNjQGhhY2t3YXRjaC5jb20+tBJqbWNjQGhhY2t3
YXRjaC5jb20=
=sTfy
-----END PGP PUBLIC KEY BLOCK-----